When using a woodworking engraving machine, we need to understand the daily care and maintenance of the woodworking engraving machine. Good care and

maintenance of the woodworking engraving machine can improve the working efficiency of the engraving machine and also extend the service life of the

engraving machine.

       The following points are included in the daily maintenance of woodworking engraving machines:

      1. Try to ensure that the continuous operation time is within 10 hours a day. The cooling water must be kept clean. At the same time, the water pump must be

able to work normally. The water axis motor must not be short of water. At the same time, pay attention to regular cooling. Change the water to prevent the water

temperature from being too high. The temperature is low in winter. At this time, we can replace the water in the water tank with antifreeze.

      2. After each use of the machine, be sure not to forget to clean it. There may be dust on the transmission system, so be sure to clean it. The platform fluid should

be kept clean, and the vibration system should be lubricated regularly every week. When lubricating, please note that the xyz optical axis uses engine oil and the screw

part uses high-speed butter. In winter, when the weather is cold and the temperature is too low, we can use gasoline to clean the screw and polished rod first, and then

refuel. Otherwise, it is easy to cause machine misalignment due to excessive resistance.

      3. When performing maintenance and inspection on electrical appliances, remember to cut off the power supply first, and wait until the monitor does not display

and the indicator light of the main circuit power supply has gone out before proceeding.

      Regarding how to maintain engraving machines, the above is some relevant knowledge that the editor has compiled for you. Pay attention to care and maintenance

when using any machine, which can not only increase work efficiency, but also extend the service life of the machine.